Anyone use a complete stroker assembly from Lunati!!
Thread Starter
Melting Slicks
Joined: Apr 2001
Posts: 3,034
Likes: 125
From: NY-South Florida
Anyone use a complete stroker assembly from Lunati!!
Looking for anyone who has had experience using Lunati's stroker spinning assembly. They have a complete assembly with 4.00" stroked forged crank (with reluctor), 6.125" rods that are offset like the factory rods, HD rod bolts (of course), forged pistons and rings and they balance the whole assembly.
Anyone! :rolleyes:
Anyone! :rolleyes:
Drifting
Joined: Jul 2000
Posts: 1,912
Likes: 0
From: South Florida
Re: Anyone use a complete stroker assembly from Lunati!! (9D9LS1)
how much does that assembly go for? is that a 383 kit?
Looking for anyone who has had experience using Lunati's stroker spinning assembly. They have a complete assembly with 4.00" stroked forged crank (with reluctor), 6.125" rods that are offset like the factory rods, HD rod bolts (of course), forged pistons and rings and they balance the whole assembly.
Anyone! :rolleyes:
Anyone! :rolleyes:
Thread Starter
Melting Slicks
Joined: Apr 2001
Posts: 3,034
Likes: 125
From: NY-South Florida
Re: Anyone use a complete stroker assembly from Lunati!! (don527)
I think jobber price goes for approx. $ 3,600.00. If you stick with the stock bore I believe its a 382. If you bore it 4.030" its a 408.
Anybody have any luck with there stuff?
Anybody have any luck with there stuff?
Team Owner
Joined: Apr 2001
Posts: 26,794
Likes: 614
From: Elmhurst, IL (West Suburb of Chicago) & Home of MEGA Horsepower
St. Jude Donor '06
Re: Anyone use a complete stroker assembly from Lunati!! (9D9LS1)
Can this safely be bored out to be a 408 without having to resleeve the block and handle about 500 rwhp on ***** out naturally aspirated set up? Any other stroker kits out there for less amount that are also reliabile,etc.
Nitrovette
Nitrovette
Thread Starter
Melting Slicks
Joined: Apr 2001
Posts: 3,034
Likes: 125
From: NY-South Florida
Re: Anyone use a complete stroker assembly from Lunati!! (Nitrovette)
No. I plan on boring and resleeving the motor. I most likey will bore it to a 4.08" bore and bring it up to a 418 ci.
Nobody on this forum has used Lunati's cranks and components for the LS1?
Nobody on this forum has used Lunati's cranks and components for the LS1?
