Question about Rollmaster installation.
Thread Starter
Melting Slicks
Joined: Apr 2001
Posts: 3,034
Likes: 125
From: NY-South Florida
Question about Rollmaster installation.
I was dry fitting the oil pump and timing set along with the Rollmaster setup. I noticed that without the front cover gasket in place the bolts that hold the oil pump on, interfere with the front cover. I then tried it with the gasket in palace and it seemed OK. Is it that close??? :crazy:
Premium Supporting Vendor
Joined: Jan 2001
Posts: 17,681
Likes: 11
From: Central Jersey
Cruise-In II Veteran
Cruise-In III Veteran
Cruise-In V Veteran
Re: Question about Rollmaster installation. (joghotrod)
Yes, the added shims behind the pump make it a very tight fit. Its a real nice chain though :)
Melting Slicks
Joined: Jan 2001
Posts: 2,635
Likes: 2
From: Aloha, Oregon
Re: Question about Rollmaster installation. (9D9LS1)
yes, that is the correct fit. very tight, but good. Nice chain, isnt it!!! I will be installing these on all jobs i do. before you put the crank pulley on, you might want to consider keying the crank, even if you're not S/C. I just did mine for the added insurance.
