EBCM - 6 years after initial Soldering
Thread Starter
Intermediate
Joined: Sep 2016
Posts: 44
Likes: 3
From: Katy, TX
EBCM - 6 years after initial Soldering
- Fixed the EBCM 6 years ago by soldering 5 spots.
- Current message: Active Handling; Service vehicle soon; followed by the active handling orange traction icon on the dash
- Pulled out the module as before and resoldered and reassembled module on the car
- After driving a few miles when brakes were applied, at 60 MPH, felt the car pull to the left from the rear. Could feel the car pull and straighten up.
- Same message as above and the light lit up.
- Is it possible that it is the wheel sensor?
- Any suggestions are appreciated !!!
Drifting
Joined: Sep 2009
Posts: 1,862
Likes: 595
From: Prescott, Arizona
C1287 and C1288 are STEERING SENSOR RATE MALFUNCTION and STEERING POSITION CIRCUIT. Both history.
Start over by clearing all codes and see what comes up next start and run by checking before engine shutdown.
Start over by clearing all codes and see what comes up next start and run by checking before engine shutdown.
