Mirror Sensor Fault Codes
Thread Starter
Instructor
Joined: Jul 2019
Posts: 137
Likes: 32
From: Bluegrass State
Mirror Sensor Fault Codes
I'm getting the following DTC's: B2262, B2264, B2263, and B2265. They are the horizontal and vertical sensor fault codes for both the drivers and passenger mirrors. I've read through the service manual and unless I've overlooked it, they tell you everything except why I would be getting these. If they did say why, it was over my head!
Any input on why I would be getting these codes is greatly appreciated. If it matters, I found the codes by connecting a scan tool to the car.
Thanks!
Any input on why I would be getting these codes is greatly appreciated. If it matters, I found the codes by connecting a scan tool to the car.
Thanks!
Moderator, Tech Contributor
Joined: Sep 2013
Posts: 15,435
Likes: 3,982
From: Cape Coral, Florida
What sets those DTC's is either the DDM or PDM (passenger or driver door module) sees the mirror position sensor signal voltage either below .1 volts or over 4.78 volts for more than 2 seconds...you have possibly a wiring issue with short to ground or to power...if this electrical stuff is over your head best to seek out an auto-electric shop !!
