Paging Phil at Dynotech
Melting Slicks
Joined: Aug 2003
Posts: 2,406
Likes: 0
From: Fly Over State
Senior Member
Cruise-In V Veteran
Re: Paging Phil at Dynotech (Bink)
Have you received my emails concerning Excedy clutch, 4.10s, roll bar and dyno tune. Thank you.
Collections Hold
Joined: Aug 2002
Posts: 2,899
Likes: 6
From: Fort Wayne Indiana
Re: Paging Phil at Dynotech (Bink)
Joel,
Apologies for the late response to your email, but we had MAJOR modem/router failure last Friday afternoon and we have not had internet access until this afternoon. One would think that after spending $17,000 on the phone/data system we have here that these kind of problems wouldn't occur so soon....:mad
I've got over 136 emails to sort through and answer this evening, so I'll get to your's then. :)
Regards,
Phil
DTE
Apologies for the late response to your email, but we had MAJOR modem/router failure last Friday afternoon and we have not had internet access until this afternoon. One would think that after spending $17,000 on the phone/data system we have here that these kind of problems wouldn't occur so soon....:mad
I've got over 136 emails to sort through and answer this evening, so I'll get to your's then. :)
Regards,
Phil
DTE
Burning Brakes
Joined: Aug 2002
Posts: 1,090
Likes: 8
From: Indianapolis Indiana
Re: Paging Phil at Dynotech (DynoTech Engineering)
Phil: I sent an email Saturday and it got kicked back several times since your email was down. Just wanted to thank you, Tim and Jeremy again for staying so late Friday to get me back on the road. See you April 2nd. Did you verify that you had two sets of 4.10 gears left? Greg
Collections Hold
Joined: Aug 2002
Posts: 2,899
Likes: 6
From: Fort Wayne Indiana
Re: Paging Phil at Dynotech (ndirishr1)
Thank you for the business as well and it was nice chatting with you at lunch.
We currently have only 1 set of the 4.10 gear set left and your name is on them. :) We're doing the best we can to find any other sets we can get our hands on for the differential we build for our customers. The 3.90 and 4.10 gaer sets are becoming very hard to come by these days...
Regards,
Phil
We currently have only 1 set of the 4.10 gear set left and your name is on them. :) We're doing the best we can to find any other sets we can get our hands on for the differential we build for our customers. The 3.90 and 4.10 gaer sets are becoming very hard to come by these days...
Regards,
Phil
Thread Starter
Safety Car
Joined: Mar 2002
Posts: 4,928
Likes: 1
Cruise-In V Veteran
St. Jude Donor '09
Re: Paging Phil at Dynotech (DynoTech Engineering)
Hey, I understand. My server was hit by 2 different viruses in 3 weeks - major pain.
I sure hope you can get at least one more set of 4.10s. :D
Thanks for the reply. :yesnod: :steering:
I sure hope you can get at least one more set of 4.10s. :D
Thanks for the reply. :yesnod: :steering:
