Separating MAT Sensor Connector Question
Race Director
Joined: Oct 1999
Posts: 17,708
Likes: 1,218
From: Phila PA, Bonita Springs FL
Re: Separating MAT Sensor Connector Question (SafetyAgentMan)
Pull the latching clip and at the same time, then pull straight out.
If you don't pop up the locking clip the sensor plug ain't movin!
If you don't pop up the locking clip the sensor plug ain't movin!
Thread Starter
Pro
Joined: Sep 2000
Posts: 692
Likes: 1
Re: Separating MAT Sensor Connector Question (YO-EL)
Thanks,
I actually had pulled the gray locking clip out completely, but I guess I was not squeezing the black clip hard enough. I finally got it to release. Next I replaced my LS1 air box lid with one from the ZO6. What a pain that was to get out until you understand how it is actually attached.
Think I will take a break and ice my back.
Regards,
Howard
I actually had pulled the gray locking clip out completely, but I guess I was not squeezing the black clip hard enough. I finally got it to release. Next I replaced my LS1 air box lid with one from the ZO6. What a pain that was to get out until you understand how it is actually attached.
Think I will take a break and ice my back.
Regards,
Howard
