B&M Ripper Question?
Dec 18, 2004 | 10:49 PM
Thread Starter
Safety Car
Joined: Dec 2003
Posts: 3,626
Likes: 1
From: Fremont California
B&M Ripper Question?
Has anyone else experinced any issuses with there B&M?
I took the Z out today for a spirited run through the mountains
and I had some problems with 2nd to 3rd shifts
2nd to 3rd shifts are usually very smooth, but today It felt like 3rd was gone?
Dec 18, 2004 | 11:27 PM
Race Director
Joined: Mar 2001
Posts: 19,965
Likes: 6,770
From: Bonneville Salt Flats
Installed one the first weekend after my '01 came in... no such problems in 3.5 years. Sure it's the shifter?
Good luck
Dec 18, 2004 | 11:34 PM
Thread Starter
Safety Car
Joined: Dec 2003
Posts: 3,626
Likes: 1
From: Fremont California
I've had mine for almost a year and never had problem, until today.
I'll take the car out tomorrow and see if the problem repeats
If not I will chalk it up to driver error
Dec 18, 2004 | 11:40 PM
Team Owner
Joined: Mar 2001
Posts: 21,325
Likes: 3,841
From: small town in S.E Pa. PA
St. Jude Donor '03-'04
four years with my ripper and I still smile with every shift.
Dec 19, 2004 | 09:30 AM
Race Director
Joined: Jan 2000
Posts: 15,707
Likes: 1
From: Lynnfield MA
Cruise-In II Veteran
Cruise-In III Veteran
Cruise-In VI Veteran
No problems and no rattles like some aftermarket units...
Dec 19, 2004 | 10:12 AM
Drifting
Joined: Oct 2002
Posts: 1,710
Likes: 0
From: Langhorne PA
Almost 2 years with mine and no problems. Like the crisp feel. Seems to just slide into 3rd without any problem.