Front break cooling set up
Thread Starter
Advanced
Joined: May 2004
Posts: 62
Likes: 0
From: Boise Idaho
Front break cooling set up
Did my 1st oil change the other day and was down in the pit looking over the underside of 06 C6. On both the left and right side of the
fascia their were black plastic (cups for lack of a better name) that are
about 5" in dia. by 4" long. In the center of this cup is a hole probably
1"+ in dia.
These holes are facing toward the front wheel areas. Questiom: Am I missing a hose that should go in that hole and lead back to the front brake areas or are these HOLES the cooling device for the brakes?
I have read other msgs here about the hose/tubes not being connected.
fascia their were black plastic (cups for lack of a better name) that are
about 5" in dia. by 4" long. In the center of this cup is a hole probably
1"+ in dia.
These holes are facing toward the front wheel areas. Questiom: Am I missing a hose that should go in that hole and lead back to the front brake areas or are these HOLES the cooling device for the brakes?
I have read other msgs here about the hose/tubes not being connected.
