Splash Guard Install
Thread Starter
Burning Brakes
Joined: Oct 2012
Posts: 960
Likes: 118
From: Panama City, Florida
Splash Guard Install
Got my Splash Guards and decided there had to be another way to install them other than removing the rear tires. I went by the instructions as far as taping them in place and marking where the hole go. I had to use a very short grease pencil to mark the holes. Then put a drill bit in my Dremal Tool. Drilled a small pilot hole where I had marked the hole locations. The pilot hole was at an angle due to lack of clearance but does not matter. Then taped the Guards back in place. Then I used a short right angle screw driver (shown in photo) and black screws to install the Guards. Turned out good for me. Took about 10 minutes per side.
Thread Starter
Burning Brakes
Joined: Oct 2012
Posts: 960
Likes: 118
From: Panama City, Florida
Good thinking to make easy install. 
Melting Slicks
Joined: Jul 2011
Posts: 2,083
Likes: 68
From: Carrollton GA
W. GA Events Coordinator
St. Jude Donor '12-'13-'14-'15
Good idea, especially if you don't have easy access to a jack.
FWIW, I recently purchased a cordless impact wrench and it makes pulling the wheels off and putting them back a snap.
Thanks for sharing your good idea.
FWIW, I recently purchased a cordless impact wrench and it makes pulling the wheels off and putting them back a snap.
Thanks for sharing your good idea.
