What am I missing
Thread Starter
Melting Slicks
Joined: Jul 2000
Posts: 2,724
Likes: 115
From: Phoenix AZ
What am I missing
I am attempting to get my gauge bezel off. The only par left is the starter switch, the sensor and the dimmer switch. I just cannot figure which was to push, pull, twist to get these off.
What am I missing?
What am I missing?
Team Owner
Joined: Sep 2005
Posts: 20,352
Likes: 568
From: Ventura County, Calif
Most people have used this DIY if you haven't seen it, may help:
http://forums.corvetteforum.com/c6-c...many-pics.html
http://forums.corvetteforum.com/c6-c...many-pics.html
Safety Car
Joined: Oct 2003
Posts: 4,024
Likes: 13
From: Loveland CO to Central Coast CA
Thread Starter
Melting Slicks
Joined: Jul 2000
Posts: 2,724
Likes: 115
From: Phoenix AZ
Thread Starter
Melting Slicks
Joined: Jul 2000
Posts: 2,724
Likes: 115
From: Phoenix AZ
Well I got the dimmer switch off but did it from outside the car. There are two release points. What I did was fold the bezel down over the steering wheel. Then standing outside the drivers side, I used two small screwdrivers to lift the release point up and it popped off.
I still cannot figure how to get the sensor off and then the starter switch
I still cannot figure how to get the sensor off and then the starter switch
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski