Brake Problems Need Help
Thread Starter
Instructor
Joined: Jun 2009
Posts: 183
Likes: 1
From: Waynesboro Virginia
Brake Problems Need Help
I replaced by brake lines with braded lines. I blade the brakes starting at the passenger rear, drivers rear, front passenger and then the front drivers. I'm not getting any air when bleeding. You can pump the brakes and have a good pedal, but while the car is running and you hit the brakes they go to the floor. I have replaced the master cylinder with the same results. Can anyone tell me what I need to do next. Thanks
Race Director
Joined: Oct 2010
Posts: 14,475
Likes: 787
From: Las Vegas NV
Did you pump the pedal a few times with the engine running and making sure the MC is full? When I replaced my pads I didn't have the system open but my pedal did go to the floor on the first push. After 3 or 4 pumps it was fine.
Instructor
Joined: Sep 2013
Posts: 103
Likes: 0
From: Wylie Texas
I replaced by brake lines with braded lines. I blade the brakes starting at the passenger rear, drivers rear, front passenger and then the front drivers. I'm not getting any air when bleeding. You can pump the brakes and have a good pedal, but while the car is running and you hit the brakes they go to the floor. I have replaced the master cylinder with the same results. Can anyone tell me what I need to do next. Thanks
Pro
Joined: Sep 2008
Posts: 562
Likes: 90
From: Tavares Florida
I just read it is right rear, left front, left rear, then right front.
http://forums.corvetteforum.com/c6-t...-for-a-c6.html
http://forums.corvetteforum.com/c6-t...-for-a-c6.html
Thread Starter
Instructor
Joined: Jun 2009
Posts: 183
Likes: 1
From: Waynesboro Virginia
Thanks everyone has been helpful with there responses. Thanks Again
I just read it is right rear, left front, left rear, then right front.
http://forums.corvetteforum.com/c6-t...-for-a-c6.html
http://forums.corvetteforum.com/c6-t...-for-a-c6.html
