Muffler help
Thread Starter
Instructor
Joined: Dec 2006
Posts: 109
Likes: 1
From: Jacksonville Fl
Muffler help
I just installed a set of Borlas on my 2011 C6 and can't get rid of a vibration. The mufflers are not touching anything nor any of the pipes, the muffler shop and I have looked at everything and can't figure out the cure. When they replaced the mufflers they removed the hangers. Looking at the parts diagram there is a right and left hangar, this could be the problem. Are they marked and if so is there a right and left for each muffler also is the right or left determined by looking from the rear of the car.
If push up on the muffler I can hear a slight ding neat the hangar
If push up on the muffler I can hear a slight ding neat the hangar
Drifting
Joined: Feb 2012
Posts: 1,430
Likes: 113
From: Brick NJ
On my 2005, which may differ from yours there is definitely a right and a left, when the over the axle pipes came out heading towards the front of the car the both the left and right pipe were leaning inward toward the center of the car to hook up with the H pipe, i would think yours would be the same.
Drifting
Joined: Feb 2012
Posts: 1,430
Likes: 113
From: Brick NJ
On my 2005, which may differ from yours there is definitely a right and a left, when the over the axle pipes came out heading towards the front of the car the both the left and right pipe were leaning inward toward the center of the car to hook up with the H pipe, i would think yours would be the same.
Le Mans Master
Joined: Jan 2006
Posts: 6,800
Likes: 2,653
From: Down south in Dixie
The Borlas on my '07 have two hangers (one for each side), and the over the axle pipes are side specific. Hope you find the problem.
FYI, mine are the older style Touring mufflers. The ones with the mufflers kind of stacked together.
FYI, mine are the older style Touring mufflers. The ones with the mufflers kind of stacked together.
Last edited by Rebel Yell; Jul 12, 2015 at 03:28 PM.
