Npp
Race Director
Joined: Sep 2007
Posts: 16,557
Likes: 2,108
From: Peoria/Phoenix AZ
C6 of Year Finalist (performance mods) 2019
Melting Slicks
Joined: Sep 2008
Posts: 2,360
Likes: 59
From: San Jose California
The exit on the passenger side of the X-pipe is straight, the 09 and up turn towards the rear of the car.
So as mentioned, the muffler itself is the same, but the pipe connecting to the muffler is different.
DJ
So as mentioned, the muffler itself is the same, but the pipe connecting to the muffler is different.
DJ
Racer
Joined: Aug 2008
Posts: 497
Likes: 21
From: Garner NC
You can also cut the pipe at the straight section, rotate it so it lines up with the 09+ x pipe, and then weld the cut. That way you don't have to cut the old NPP mufflers and then you can sell them or keep them as spares if need be. I did this for a friend and it fit in perfectly. The pipes are the same except for the angle of the inlet. If you can't weld you could probably use a 2.5 inch butt joint exhaust clamp.
Last edited by Paratrooper307; Nov 28, 2015 at 04:47 PM.
