C6 turn signal problem
Thread Starter
Advanced
Joined: Sep 2019
Posts: 95
Likes: 2
C6 turn signal problem
Hi, I have a 2012 corvette base, I recently installed aem wideband (yesterday) I ran the wire thru the fender liner and up behind the battery on passengers side, there is a rubber grommet where the lines go to the fuse box, I ran it thru there (I know I shouldn’t have but I used a box cutter to cut the grommet a little to get it thru, I also used a screwdriver to help push it thru. As I have it done now, I started the car up and well my turn signal blinks fast, and the front signal doesn’t work. I changed the bulb and nothing, I think there is a chance I damaged a wire while trying to run the wideband wire thru that grommet, how should I go about fixing it? Should I try removing the whole grommet and maybe try and pull the wires out a little to inspect?? I’m really at a loss of what to do please any help would be appreciated!
Race Director
Joined: Sep 2009
Posts: 11,351
Likes: 2,445
From: Eastern
I would check that bulb or socket again before I go digging in the wiring. It's possible that the ground wire at the socket is broken, the bulb is not making a good connection, or that the ground is not making a good connection.
Good luck
Good luck
Thread Starter
Advanced
Joined: Sep 2019
Posts: 95
Likes: 2
thank you, I’ll update when I try to fix
