codes
Thread Starter
Advanced
Joined: Oct 2013
Posts: 66
Likes: 12
From: Tulsa
C4 of Year Finalist (performance mods) 2019
codes
I bought a chineese obd tech11 to help with my problems. Problem is, How to get started. Does anyone know how to get an 05 convertible on the thing and run diagnostics? I have been going through pages and pages of the manual (online) mostly about setup. I'm not finding how you get your specific vehicle in there.
I need to check on "service active handling system and service ABS system" notifications on the dash.
Any help on how to use one of these things would be greatly appreciated.
Thanks,
Jim
I need to check on "service active handling system and service ABS system" notifications on the dash.
Any help on how to use one of these things would be greatly appreciated.
Thanks,
Jim
Race Director
Joined: Dec 2013
Posts: 12,501
Likes: 3,627
In tech2win from the blue screen and it connected to the OBDII port below the steering wheel to connect it to the car,
press enter
F0 diagnostics,
2005 for the year of car,
passenger car
Chevrolet
Y body car
F0 VCS
enter trans type
Enter a few more times for the two other screens,
Then F0 to pull the DTC's
press enter
F0 diagnostics,
2005 for the year of car,
passenger car
Chevrolet
Y body car
F0 VCS
enter trans type
Enter a few more times for the two other screens,
Then F0 to pull the DTC's
Safety Car
Joined: Dec 2006
Posts: 4,574
Likes: 1,649
From: Pearland / Houston Tx
The manual was too big to print for me. But I did print a hard copy of the menu paths in the device,
See post #5 in this thread.....https://www.corvetteforum.com/forums...u-listing.html
See post #5 in this thread.....https://www.corvetteforum.com/forums...u-listing.html
