Removing wide-body rear brake vents
#1
Race Director
Thread Starter
Member Since: Nov 2017
Location: Prosper TX/Austin TX
Posts: 10,894
Received 8,831 Likes
on
4,249 Posts
2020 C6 of the Year Winner - Modified
Removing wide-body rear brake vents
I had previously painted my rear brake vent inserts inferno orange to match the car. I never got around to covering them with Xpel so they got pretty chipped up. I decided to revert them back to black so here's a quick how to remove them if you want to paint them or replace them.
tools needed: thin plastic trim removal tool(s). Slide the trim removal tool under the edge of the vent about midway from both the top and the bottom where these little notches snap into these slots. There are two on each side of the vent. Then simply pop the insert out.
tools needed: thin plastic trim removal tool(s). Slide the trim removal tool under the edge of the vent about midway from both the top and the bottom where these little notches snap into these slots. There are two on each side of the vent. Then simply pop the insert out.
The following 2 users liked this post by JABCAT:
FAUEE (06-03-2023),
Geoff13IOM6GS (06-05-2023)
The following users liked this post:
JABCAT (02-03-2024)
#3
Race Director
Thread Starter
Member Since: Nov 2017
Location: Prosper TX/Austin TX
Posts: 10,894
Received 8,831 Likes
on
4,249 Posts
2020 C6 of the Year Winner - Modified
#4
Race Director
That sort of part screams to be 3D printed, but I suspect people want the car weave effect, which 3D printed material wouldn't have..
#5
Pro
How'd the Foreman spatula work?
The following users liked this post:
rockinSeat (06-05-2023)
#6
Race Director
Thread Starter
Member Since: Nov 2017
Location: Prosper TX/Austin TX
Posts: 10,894
Received 8,831 Likes
on
4,249 Posts
2020 C6 of the Year Winner - Modified
The following users liked this post:
Corvette_Dez (06-05-2023)