Headlight access flap
Drifting
Joined: Apr 2021
Posts: 1,934
Likes: 1,126
From: Peoria, AZ
2023 C6 of the Year Finalist - Modified
I ended up fabricating my own. Used the rubber "mat" that comes on the top of rolling tool boxes, (had an extra piece that I acquired somewhere back in time). Made a template out of thin cardboard including where the holes are, and cut it out with a pair of scissors and it came out perfect. Cost me nothing except about 20 minutes of my time.
Burning Brakes
Joined: Oct 2007
Posts: 792
Likes: 195
From: NC
I ended up fabricating my own. Used the rubber "mat" that comes on the top of rolling tool boxes, (had an extra piece that I acquired somewhere back in time). Made a template out of thin cardboard including where the holes are, and cut it out with a pair of scissors and it came out perfect. Cost me nothing except about 20 minutes of my time.
Thread Starter
Advanced
Joined: Jun 2023
Posts: 95
Likes: 35
From: Louisiana
I ended up fabricating my own. Used the rubber "mat" that comes on the top of rolling tool boxes, (had an extra piece that I acquired somewhere back in time). Made a template out of thin cardboard including where the holes are, and cut it out with a pair of scissors and it came out perfect. Cost me nothing except about 20 minutes of my time.
