RPM performance in Garner NC
#1
Advanced
Thread Starter
RPM performance in Garner NC
Took car to RPM in NC for AHP heads (MS90 guides and BTR springs but no porting or shaving} and mild cam should be done by Friday. Not going to be big HP gain but the peace of mind that goes with the heads, well worth it.
Steve
Steve
#4
Advanced
Thread Starter
It's a mild cam TSP (N) all I know is 635 lift What I told them when ordering was I wanted Mid range power not top end and this is what they suggested. Also a conservative tune.
#6
Advanced
Thread Starter
Got a call from Mark at RPM of NC today car is ready to pickup, can't wait.Going to go tomorrow and try to get home before storms hit, have never drove it in rain.
#9
Advanced
Thread Starter
I just got home from picking car up from RPM in NC. AHP heads MS90 guides BTR springs, that is all work to the heads, TSP 2.2 cam 234/246, 635/635, 112.5 LSA and a Hall tech CAI. Car was tuned on Dynojet Dyno, Max Power=527.98 RPM=6.31K Max Torque=474.04 RPM=4.96K Car drives very good and sounds great am totally satisfied with all work and car so far.
Steve
Steve
The following users liked this post:
got2hav1 (06-22-2018)