[ZR1] LPE snout clearance question
#1
Instructor
Thread Starter
LPE snout clearance question
I’m looking to run a little more boost, current setup is a 2.6 upper on an lpe snout and IW 10% lower. Don’t really want to deal with swapping lower pulleys right now, I would like to go to as small as possible on the upper but was wondering if the Lpe snout needs to be machined or clearanced at all and if so at what size pulley. Thanks in advance.
#5
Pro
I use a stock size belt with a 76mm idler on the drivers side. I have a Synergy Intake, 102mm TB, Kong race ported LPE snout, Kong race ported blower, untouched heads, a BTR Stage 3 cam and 2" headers and see between 17-18lbs.
#7
Instructor
Thread Starter
Thanks for the info. Funny enough that is exactly the same setup I have. What kind of numbers did you make if you don’t mind?
#10
Instructor
Thread Starter