C6 NOS install
Thread Starter
1st Gear
Joined: May 2008
Posts: 1
Likes: 0
C6 NOS install
Here are a few pics of my buddies C6 corvette. I just installed a NOS kit in it. I just signed up to this site and deff got some good info about the install here. 
The parts.
-NOS LS2 plate kit (jetted to 100hp, 125 or 150)
-ZEX Programmable TPS Switch - Used to arm Fuel/N2O solenoids when -DBW TB is only at full throttle
-MSD RPM Activated Window Switches - Used to arm solenoid relay between set rpm points.
I installed the Zex and MSD box's up high under the dash and where a bitch to wire up but make the system nice and safe.
It all ended up nice and clean but I should have just slapped the kit in there as its coming out at the end of summer though >
Can't wait to see it at the track :rockin:
Here is a pic of my ride. Its no Corvette but with 415whp it goes ok
The parts.
-NOS LS2 plate kit (jetted to 100hp, 125 or 150)
-ZEX Programmable TPS Switch - Used to arm Fuel/N2O solenoids when -DBW TB is only at full throttle
-MSD RPM Activated Window Switches - Used to arm solenoid relay between set rpm points.
I installed the Zex and MSD box's up high under the dash and where a bitch to wire up but make the system nice and safe.
It all ended up nice and clean but I should have just slapped the kit in there as its coming out at the end of summer though >
Can't wait to see it at the track :rockin:
Here is a pic of my ride. Its no Corvette but with 415whp it goes ok
