Build help
Thread Starter
Racer
Joined: Jan 2007
Posts: 447
Likes: 11
From: New York
Build help
I have a 2005 m6 that im rebuilding the rearend on now. After that the engine is the next step.
my goal is 700 whp
i have had 2 supercharged corvettes (c5 & c6) before but i have never build an engine so now its the time.
my plan:
ecs novi1500 no restrictor -->14-15psi
ecs blover cam
arh 1 7/8 (on the car now)
next step is to forge my ls2
what cr should i aim for?
i was planing to use mu stock crank but what pistons and rods should i use i want to keep it as cheap as possible as the shipping from us to me in sweden is going to cost as mutch as the parts.
is high mile an issue for a crank?
i dont know about fuel yet ether e85 (is everywhere here in sweden) or pump gas with meth/water?
(100% meth is very expensive here in sweden but 50/50 is cheap)
//Fredrik
my goal is 700 whp
i have had 2 supercharged corvettes (c5 & c6) before but i have never build an engine so now its the time.
my plan:
ecs novi1500 no restrictor -->14-15psi
ecs blover cam
arh 1 7/8 (on the car now)
next step is to forge my ls2
what cr should i aim for?
i was planing to use mu stock crank but what pistons and rods should i use i want to keep it as cheap as possible as the shipping from us to me in sweden is going to cost as mutch as the parts.
is high mile an issue for a crank?
i dont know about fuel yet ether e85 (is everywhere here in sweden) or pump gas with meth/water?
(100% meth is very expensive here in sweden but 50/50 is cheap)
//Fredrik
