WTB: Looking for fog light housings
#1
Want to buy a passenger Z06 fog light housings
Hey everyone, I'm looking for a driver side fog light housing in decent to good condition. I would prefer it to not be cloudy, but I can probably deal with a slight amount of sun damage. The main thing I'm looking for is a housing that hasn't been taken apart before(want to make sure it wasnt glued together with epoxy or another permanent glue), and that both of the upper tabs on the lens (the small little clear tabs on the top of the lens) are intact.
Last edited by Mocha_jo1; 12-11-2018 at 08:36 PM.
#4
Drifting
Member Since: Nov 2006
Location: Sierra Mtns. The Great State Of Jefferson
Posts: 1,810
Received 169 Likes
on
128 Posts
https://www.corvetterecycling.com/se...&show=9&page=1
I just bought a left side fog light and it was in good shape.
I just bought a left side fog light and it was in good shape.
#5
https://www.corvetterecycling.com/se...&show=9&page=1
I just bought a left side fog light and it was in good shape.
I just bought a left side fog light and it was in good shape.
Last edited by Mocha_jo1; 12-03-2018 at 12:54 PM.
#7
Drifting
Member Since: May 2013
Location: Mountain View California
Posts: 1,317
Received 154 Likes
on
112 Posts
Check the big shopping site for brand new less than the site you were told to check out. Most fog lights are going to be well pitted from road rash because there so low to the ground. Very