FS: 321 Stainless Forward Turbo Headers
#1
Former Vendor
Thread Starter
321 Stainless Forward Turbo Headers
These were fabbed up for our shop race car for front mount twins. We recently decided to put the turbos near the firewall, so these are available:
- For LS engines
- Fabbed for shop race car
- All 321 Stainless
- Cones inside merge collectors
- Collector outlets are 3.5 inches
- Primaries are 1.75" ID
- Not welded (only tacked)
- V-flange clamp not included
- Can be welded if purchased
Asking $895
Email todd@vengeanceracing.net
- For LS engines
- Fabbed for shop race car
- All 321 Stainless
- Cones inside merge collectors
- Collector outlets are 3.5 inches
- Primaries are 1.75" ID
- Not welded (only tacked)
- V-flange clamp not included
- Can be welded if purchased
Asking $895
Email todd@vengeanceracing.net
Last edited by Vengeance Racing; 02-10-2020 at 03:27 PM.
#5
They aren't even welded, there's a ton of work left to do to these before they can even be used, the top set of headers 2 of the pipes aren't even welded to the flange ! if you're selling them "AS IS" you might want to point out that they need to be fitted and finished welding. $1000 for these is way too much.
#6
Former Vendor
Thread Starter
They aren't even welded, there's a ton of work left to do to these before they can even be used, the top set of headers 2 of the pipes aren't even welded to the flange ! if you're selling them "AS IS" you might want to point out that they need to be fitted and finished welding. $1000 for these is way too much.
#7
Thinking about it, I can finish doing all the welding and fab work.
The following users liked this post:
Vengeance Racing (01-24-2020)