hpt basic e85 table
Thread Starter
thing knower
Joined: Mar 2017
Posts: 3,404
Likes: 942
From: wpb
hpt basic e85 table
hey all... looking to enable my e85 prior to tuning...
would like to copy a generic table in for ethanol so I can get the gas cycled out of my tanks before going in for tuning...
thoughts?
would like to copy a generic table in for ethanol so I can get the gas cycled out of my tanks before going in for tuning...
thoughts?
Race Director
Joined: May 2004
Posts: 16,667
Likes: 1,209
From: Raleigh, NC
St. Jude Donor '15
Huh? I don't think you understand how it works.
Assuming it's already tuned on gas, you literally just turn the flex fuel sensor on in the tune (after connecting it, obviously) and make sure the stoich ratio table is correct for different E contents (copy it over from a factory flex fuel enabled vehicle) and it figures out fueling on it's own from there
That's pretty much it.. and the beauty of it. Fueling adjusts on its own.
Assuming it's already tuned on gas, you literally just turn the flex fuel sensor on in the tune (after connecting it, obviously) and make sure the stoich ratio table is correct for different E contents (copy it over from a factory flex fuel enabled vehicle) and it figures out fueling on it's own from there
That's pretty much it.. and the beauty of it. Fueling adjusts on its own.
Last edited by schpenxel; Dec 17, 2020 at 01:41 PM.
