Any dyno results?? Thanks
Car is done / tuned
Thread Starter
Racer
Joined: Jun 2005
Posts: 369
Likes: 0
From: SAN ANTONIO TX
Car is done / tuned
ok, finally got tuned done.....
mods....
PP stock heads
cam---will post specs later
kooks headers
kooks x-pipe w/cats
corsa sport exhaust
breathless intake
custom tune
spent about $7000.00 to all this done
dyno sheet
mods....
PP stock heads
cam---will post specs later
kooks headers
kooks x-pipe w/cats
corsa sport exhaust
breathless intake
custom tune
spent about $7000.00 to all this done
dyno sheet
Last edited by MRZ5; Aug 2, 2005 at 08:10 PM.
Safety Car
Joined: Aug 2004
Posts: 4,067
Likes: 62
From: Houston Texas
Honestly, with those mods I would have expected 440rwhp, what are your cam specs. I have seen 400rwhp on a cam and headers alone. I did notice that it was dynoed in 96 degrees 
not the best conditions.
not the best conditions.
Pro
Joined: Feb 2002
Posts: 744
Likes: 1
From: Houston Tx
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Thread Starter
Racer
Joined: Jun 2005
Posts: 369
Likes: 0
From: SAN ANTONIO TX
dyno
ok, tuned out on a mustang dyno, a/f running in mid 11's, leaned out to mid 12's and power stayed the same, so kept it back @ 11's, car does feel like a different moster, feels great
when I was done tuning went back to original dyno jet too see gains from my base line
when I was done tuning went back to original dyno jet too see gains from my base line
Racer
Joined: Feb 2005
Posts: 460
Likes: 0
You may have left some power on the table with the tuning or your cam selection.
I did similiar mods.
Kooks w cats
Magnaflows
160 thermostat
Cam 224/230 581/592 114.........Dual springs, pushrods and retainers
Custom tuning.....Z industries
Dynojet 415 RWHP 398 RWTQ
Left the heads alone. They flow pretty good as is.
I did similiar mods.
Kooks w cats
Magnaflows
160 thermostat
Cam 224/230 581/592 114.........Dual springs, pushrods and retainers
Custom tuning.....Z industries
Dynojet 415 RWHP 398 RWTQ
Left the heads alone. They flow pretty good as is.
Last edited by Fredo; Aug 3, 2005 at 02:13 PM.