A-Arm Bushings: Poly or Spherical
Team Owner
Joined: Jul 1999
Posts: 50,808
Likes: 10
From: Buy USA products! Check the label! Employ Americans
there is no play in a end link how can it make noise?
doubt you want spherical bearing on a street car. You can never run that hard on the street in any case.
VBP poly bushing are nice.
doubt you want spherical bearing on a street car. You can never run that hard on the street in any case.
VBP poly bushing are nice.
Team Owner
Joined: Jan 2004
Posts: 38,772
Likes: 621
From: Boston MA
St. Jude Donor '06-'07-'08,'12-'13
How hard are these to replace ?
and does this cut down on wheel hop ?
http://www.pfadtracing.com/products/...&search=&page=
and does this cut down on wheel hop ?
http://www.pfadtracing.com/products/...&search=&page=
Burning Brakes
Joined: Mar 2006
Posts: 906
Likes: 1
From: SF Bay CA
How hard are these to replace ?
and does this cut down on wheel hop ?
http://www.pfadtracing.com/products/...&search=&page=
and does this cut down on wheel hop ?
http://www.pfadtracing.com/products/...&search=&page=
Racer
Joined: Mar 2006
Posts: 324
Likes: 0
From: Kalispell Montana
The last time I installed polys was in 82.... A arms and sway bars on the new Z-28. They really did tighten everything up, but were so noisy they just about drove me nuts! I had the arms out several times, but never did get them to stop barking completely. Is this still a problem or have they gone to a different composition poly or something?
