Damaged pivot cup :(
Thread Starter
Intermediate
Joined: Apr 2006
Posts: 39
Likes: 0
From: Mishref Kuwait
Damaged pivot cup :(
Hi there
I damaged the pivot cup (the plastic bearing cup at the bottom of the lever) by mistake when I tried to install the B&M shifter !!!!
where can I found a new one to replace it ?
Is there an aftermarket pivot cup ?
I damaged the pivot cup (the plastic bearing cup at the bottom of the lever) by mistake when I tried to install the B&M shifter !!!!
where can I found a new one to replace it ?
Is there an aftermarket pivot cup ?
Team Owner
Joined: Jun 2001
Posts: 26,714
Likes: 344
From: Houston, TX
On C5's, you had to buy a whole new shifter to get one - I assume it's the same on C6s. There supposedly was someone on the Mustang Forum who sold them, but I don't know who it was. I never destroyed one, but had the shifter out a few times and lived in fear of tearing it up just for that reason.
I'd post in the C5 section as well. By now, there might be someone with one laying around - I'm guessing they are the same on C5 & C6's.
Good Luck.
I'd post in the C5 section as well. By now, there might be someone with one laying around - I'm guessing they are the same on C5 & C6's.
Good Luck.
