Just installed C6Z front spring
Thread Starter
Le Mans Master
Joined: Oct 2006
Posts: 5,078
Likes: 19
From: Cumming, GA
Just installed C6Z front spring
Just completed the install in my garage the other night. Do not have driving impression at this point as it is still on stands awaiting Baer rotors that will hopefully be here today.
Visually there is a BIG difference from my BASE spring to C6Z spring. Should have taken a picture but it was late and I was rushing.
Sitting side by side the base arches 2-3" higher than the C6Z spring. Everything else is the same, but I assume the stiffness difference is driven off of this difference in arch.
I look forward to getting the brakes on and taking it for a spin to feel it out. Install was very basic and straight forward. Dropping the lower control arm was somewhat a challenge until I broke out a 12" long 2x4 and the hammer.
Will reply in this thread once car is mobile again.
Visually there is a BIG difference from my BASE spring to C6Z spring. Should have taken a picture but it was late and I was rushing.
Sitting side by side the base arches 2-3" higher than the C6Z spring. Everything else is the same, but I assume the stiffness difference is driven off of this difference in arch.
I look forward to getting the brakes on and taking it for a spin to feel it out. Install was very basic and straight forward. Dropping the lower control arm was somewhat a challenge until I broke out a 12" long 2x4 and the hammer.
Will reply in this thread once car is mobile again.
