Cags disconnect access question
Thread Starter
Burning Brakes
Joined: Jan 2006
Posts: 983
Likes: 2
From: CT
Cags disconnect access question
Last edited by harddrivin1le; Aug 24, 2008 at 10:47 PM.
Thread Starter
Burning Brakes
Joined: Jan 2006
Posts: 983
Likes: 2
From: CT
Will the fuse still "blow" as intended with a resistor soldered into place?
Last edited by harddrivin1le; Aug 25, 2008 at 08:18 AM.
Pro
Joined: Jun 2005
Posts: 538
Likes: 41
From: Alameda CA
Thread Starter
Burning Brakes
Joined: Jan 2006
Posts: 983
Likes: 2
From: CT
Really.
Just cutting the window and performing the soldering will take more time than installed the regular CAGS device - for most of us, anyway.
I think it's a great mod, but it's more of an electronics tech guru specialty mod than a broad based mod. (Fine soldering alone is not a broad-based skill and this mod requires it.)
Maybe you should sell them. I'd buy two of them for $25 (including shipping) as long as you check do a quick multi-meter QC check before you send them out to me.
Shoot me a private message if you're interested in the transaction.
Just cutting the window and performing the soldering will take more time than installed the regular CAGS device - for most of us, anyway.
I think it's a great mod, but it's more of an electronics tech guru specialty mod than a broad based mod. (Fine soldering alone is not a broad-based skill and this mod requires it.)
Maybe you should sell them. I'd buy two of them for $25 (including shipping) as long as you check do a quick multi-meter QC check before you send them out to me.
Shoot me a private message if you're interested in the transaction.
Last edited by harddrivin1le; Aug 25, 2008 at 07:09 PM.
