Zo6 headers?? Help
Melting Slicks
Joined: Jul 2007
Posts: 2,052
Likes: 14
I run C6Z Dynatech 1 7/8 lomg tubes BUT you will need the C6Z mid pipe (cat or offroad) as well as the C6Z axle back. The standard C6 axle back is 2.5 (vs the 3.0 on the C6Z) and they exit at a slightly different angle so you would need to have a shop weld the system up if you DON"T have the C6Z axle back. Here is my thread-
http://forums.corvetteforum.com/c6-t...ll-thread.html
http://forums.corvetteforum.com/c6-t...ll-thread.html
Thread Starter
Instructor
Joined: Jul 2011
Posts: 153
Likes: 1
From: KCMO
I run C6Z Dynatech 1 7/8 lomg tubes BUT you will need the C6Z mid pipe (cat or offroad) as well as the C6Z axle back. The standard C6 axle back is 2.5 (vs the 3.0 on the C6Z) and they exit at a slightly different angle so you would need to have a shop weld the system up if you DON"T have the C6Z axle back. Here is my thread-
http://forums.corvetteforum.com/c6-t...ll-thread.html
http://forums.corvetteforum.com/c6-t...ll-thread.html
good enough, found all I needed
