rough idle
Thread Starter
Heel & Toe
Joined: Aug 2010
Posts: 17
Likes: 0
rough idle
i have notice that when i step on the clutch to stop the engine rpm goes down to around 400 and back up to 1200 and finally stays around 800-900 rpm. I have the SLP blackwing and i have notice that is not sitting correctly on the two pins that stick up. Any ideas of what might be causing it not to idle smooth?
Tech Contributor
Joined: Dec 2006
Posts: 10,962
Likes: 29
From: Van Buren Arkansas
Wounded Warrior Escort '11
I would look for air leaks at the airbridge such as the bottom not attached/clamped properly. If things are sitting there correctly when you're looking at it, then something is wrong. Un-metered air getting past the MAF will cause you mixture problems.
