[/IMG]
06 LS2 Dyno check it out
Thread Starter
Racer
Joined: Mar 2009
Posts: 374
Likes: 0
From: Newark New York
06 LS2 Dyno check it out
My car got strapped down today and it did very well. Mods are New Era Streetsweeper Cam ( 236/240 631/612 111 LSA), Ported heads (Done by Mike at New Era), Ported TB and Ported Stock Intake Manifold, Kooks 1 7/8 headers with off road X pipe and DMH electric cutouts and VaraRam CAI. After all was done it made 477 RWHP and 427 RWTQ with the cutouts open. It did 470 RWHP with the cutouts closed. O yea and it has 96k miles on it!! All Runs were made on a DynoJet. I am very happy with the results and the guys at New Era are top notch and very easy to work with! I will post up a video soon and I will try and scan the dyno sheet and also post it. 
Thread Starter
Racer
Joined: Mar 2009
Posts: 374
Likes: 0
From: Newark New York
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Thread Starter
Racer
Joined: Mar 2009
Posts: 374
Likes: 0
From: Newark New York
LOL. Best part is when the cutouts are closed it sounds like a stock LS2.... You can hear the lope of the cam but very quiet. I will try and get an idle video of it and post it.
Thread Starter
Racer
Joined: Mar 2009
Posts: 374
Likes: 0
From: Newark New York
Tune is great. Cruises down the highway at 70 just like stock and normal driving is good too considering the size of the cam. A little bucking at low speeds under 2k RPM's but easy to deal with being an M6!
