When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I think you should make a rear bumper like that to fit a stock C7 -- would look great ...and the line where it joins the quater panel looks very similar to the angle of the C7
It's certainly would be a head turner. But take a look at the Supervettes thread in the C6 general forum section. Estimated pricing for the conversion is $59,000.....I think this would be rather expensive for most of the people on this forum.
It's certainly would be a head turner. But take a look at the Supervettes thread in the C6 general forum section. Estimated pricing for the conversion is $59,000.....I think this would be rather expensive for most of the people on this forum.
Gosh, if I could afford a $59K conversion plus the cost of a base vette, I would just go for a ZR1 instead. I'd rather have the go fast goodies than the looks. I guess there might be small number of people that could do this to a ZR1 but I cannot see many of these being sold.
Gosh, if I could afford a $59K conversion plus the cost of a base vette, I would just go for a ZR1 instead. I'd rather have the go fast goodies than the looks. I guess there might be small number of people that could do this to a ZR1 but I cannot see many of these being sold.
they'll prolly all go to saudi,,they can afford it..
I think you should make a rear bumper like that to fit a stock C7 -- would look great ...and the line where it joins the quater panel looks very similar to the angle of the C7