katech / Tilton slave cylinder
Thread Starter
Intermediate
Joined: Nov 2013
Posts: 49
Likes: 16
From: Ohio
katech / Tilton slave cylinder
Ive searched other threads and found only mention of the product. Just wondering if anyone is using the katech set up yet in a c6 Z ? Will it work in place of either zr1 or standard slaves?
Team Owner
Joined: Sep 2005
Posts: 20,352
Likes: 568
From: Ventura County, Calif
I have no personal experience but I've watched the discussions in the Z06 Forum. Seems all positive reviews. I don't know what you've read here so here are a few discussions that have some good info:
http://forums.corvetteforum.com/c6-z...the-track.html
http://forums.corvetteforum.com/c6-z...-cylinder.html
http://forums.corvetteforum.com/c6-z...r-spacing.html
http://forums.corvetteforum.com/c6-z...the-track.html
http://forums.corvetteforum.com/c6-z...-cylinder.html
http://forums.corvetteforum.com/c6-z...r-spacing.html
Thread Starter
Intermediate
Joined: Nov 2013
Posts: 49
Likes: 16
From: Ohio
Thanks Rick! I had already seen the first two but the third was a help. It seems the stroke is the same from ZR1 to ZO6 but the stand off height from base to bearing is different between the two. May have to adjust spacing behind base. Running a Spec super twin in a ZO6. I will get measurements and give to Jason.
