vararam intake install question
Thread Starter
Instructor
Joined: Oct 2011
Posts: 108
Likes: 0
From: Tampa FL
vararam intake install question
Hello, I am installing the vararam snake charmer 2 intake and i am at the point where i need to remove the "screws" that hold the shroud in place towards the bottom/front of the shroud. they appear to be some sort of pop clip and as much as i pry they wont pop out. they are definitely not threaded screws. any advice?
Race Director
Joined: Mar 2005
Posts: 11,549
Likes: 27
From: Southampton NJ
Hello, I am installing the vararam snake charmer 2 intake and i am at the point where i need to remove the "screws" that hold the shroud in place towards the bottom/front of the shroud. they appear to be some sort of pop clip and as much as i pry they wont pop out. they are definitely not threaded screws. any advice?
Thread Starter
Instructor
Joined: Oct 2011
Posts: 108
Likes: 0
From: Tampa FL
http://forums.corvetteforum.com/c6-t...ll-review.html
i found it but it doesn't really answer my question unfortunately.
i found it but it doesn't really answer my question unfortunately.
Race Director
Joined: Mar 2005
Posts: 11,549
Likes: 27
From: Southampton NJ
Sorry I thought that was your problem. I cut my shroud not replace with a cut one. But I did cut al the way down to the bottom of the shroud removing it all to the cross frame on the bottom removed the screws and pulled up hard and it in clipped
Melting Slicks
Joined: Oct 2010
Posts: 2,220
Likes: 16
From: Sugarhill Ga
are you talking about the Christmas trees that hold the panel onto the lower fascia? they just pull out, it is a pain because both panels flex. on the passenger side be careful of the ac lines, the air bag sensor, the outside temp sensor and hood light if equipped.
Thread Starter
Instructor
Joined: Oct 2011
Posts: 108
Likes: 0
From: Tampa FL
thanks, i finally got it installed...with a few cuts to show for it lol...its hesitated a couple times though when starting it since install...might need a tune finally? i have long tube headers and borla mufflers already.
