RPMS Hang
Thread Starter
Instructor
Joined: Aug 2010
Posts: 155
Likes: 0
From: Fort Worth Tx
RPMS Hang
All, I just finished up with a cam install. While at it, I did timing chains, under drive pulley, upgraded springs with moly pushrods, and morel lifters.
It was more work than I anticipated, and it seems I still have things to work on.
While it seems to run fine, the RPMS do not fall, and in some cases even rise with no throttle input. I have been looking for a vacuum leaks but haven't found one.
I also have installed a haltech cold air intake , and LG long tube headers. The tune was by mail order. If you would, check out the video and offer any help you can. Thanks
It was more work than I anticipated, and it seems I still have things to work on.
While it seems to run fine, the RPMS do not fall, and in some cases even rise with no throttle input. I have been looking for a vacuum leaks but haven't found one.
I also have installed a haltech cold air intake , and LG long tube headers. The tune was by mail order. If you would, check out the video and offer any help you can. Thanks
Last edited by orange rush; Jun 16, 2014 at 09:06 PM. Reason: youtube
