2" headers and LS2
Thread Starter
Advanced
Joined: Nov 2004
Posts: 87
Likes: 0
From: Waco TX
2" headers and LS2
Ok so hears the deal, I'm going to do a heads/cam/intake and full bolt on set up on my 2006 LS2. After the car is payed off I'm going to do a Procharged 408. My question is I only want to buy headers once so can I get away with using 2" headers on this build so I can use them again on the next build ? I would think I could and the LS2 would like them. I had a similar build in a 2000 LS1 Camaro Z28 with 1 7/8 Kooks headers and the car loved them. So I would think a LS2 built pretty much the same way would run good with 2" headers. Thoughts ?
Thread Starter
Advanced
Joined: Nov 2004
Posts: 87
Likes: 0
From: Waco TX
Forgot to mention the heads will be my existing 243's that I'll have worked by Phil at Advanced Induction along with a custom grind roller cam from him also. Not sure what intake I'm going with yet.
Team Owner
Joined: Nov 2006
Posts: 21,136
Likes: 212
From: Long Island New York
There were some tests done a couple years ago comparing the 3/4 and 7/8 tubes and there was really no difference between the two on similarly modified S/C Vettes. I'm pretty sure 2" will hurt tq. Who makes them anyway?
Drifting
Joined: Mar 2006
Posts: 1,489
Likes: 5
From: Atlanta GA
http://forums.corvetteforum.com/c6-t...re-better.html
2" headers don't seem so bad anymore
