looking for power window electrical schematic
Thread Starter
Melting Slicks
Joined: Dec 2011
Posts: 2,690
Likes: 116
From: Richmond area Va
looking for power window electrical schematic
its an 08z if that matters.
looking for quick way to hotwire the window to roll up without any computers on board.
thanks
this what ive found so far
http://www.autozone.com/repairinfo/r...96b43f80cb17e9
looking for quick way to hotwire the window to roll up without any computers on board.
thanks
this what ive found so far
http://www.autozone.com/repairinfo/r...96b43f80cb17e9
Last edited by MIGHTYM0USE; Dec 9, 2015 at 10:30 AM.
Race Director
Joined: Sep 2009
Posts: 11,353
Likes: 2,445
From: Eastern
its an 08z if that matters.
looking for quick way to hotwire the window to roll up without any computers on board.
thanks
this what ive found so far
http://www.autozone.com/repairinfo/r...96b43f80cb17e9
looking for quick way to hotwire the window to roll up without any computers on board.
thanks
this what ive found so far
http://www.autozone.com/repairinfo/r...96b43f80cb17e9
It may be difficult to override the circuit because it goes through a Computer data line #10 Brown to (19 Brown wire 1046) to send the signal to the driver side motor, and through #10 Brown to (19 tan wire 1046) for the passenger motor.
However, Good Luck in your quest and report back if it can indeed be done without shorting something out.
Last edited by 4SUMERZ; Dec 9, 2015 at 06:23 PM.
Le Mans Master
Joined: Aug 2000
Posts: 6,486
Likes: 1,659
From: Las Vegas NV
Just remember-- you might have a very hard time opening or closing the door with the window locked in the fully raised position. The window seals are in the way.
(The C6 indexes the window up/down slightly for opening/closing the door)
(The C6 indexes the window up/down slightly for opening/closing the door)
