Looking for cam kit advice
Thread Starter
Instructor
Joined: Mar 2014
Posts: 197
Likes: 18
From: Cabot Arkansas
Looking for cam kit advice
So this is for my 2012 ZR1. I have the corvette racing CAI. I’ve ordered a ARH header and x pipe and the lingenfelter pulley kit. I’d like to have something on the aggressive side but not so much that I couldn’t drive it 1k miles one way without issues. I’m looking to do a full cam kit on this.
Le Mans Master
Joined: Dec 2005
Posts: 6,999
Likes: 1,685
From: Southeast TX
High 220's to low 230's on the intake. High 230's on the exhaust. 115 or 116lsa with 3 or 4 degrees of advance ground in. Lift not much more than .610. That one should chop real nice with even a little lope at idle. A good tune would limit drivability issues. With a good set of springs and push rods, reliability shouldn't be an issue. That's not a super aggressive cam, but I'm not a big fan of something like that in such a fine ride.
