Speed Engineering Headers
Thread Starter
Pro
Joined: Aug 2011
Posts: 506
Likes: 57
From: New York
Speed Engineering Headers
Hello. I have
a set of Speed Engineering Longtubes I am ready to install. Their Xpipe has been out of stock for a while. Does anyone know what the center to center measurement of their Xpipe is.
Thanks
Matt
a set of Speed Engineering Longtubes I am ready to install. Their Xpipe has been out of stock for a while. Does anyone know what the center to center measurement of their Xpipe is.
Thanks
Matt
Last edited by renegade69; Oct 21, 2021 at 03:49 PM.
Melting Slicks
Joined: Feb 2017
Posts: 3,295
Likes: 1,283
From: Phoenix, AZ to Quakertown, PA.
C6 of Year Finalist (appearance mods) 2019
Melting Slicks
Joined: Nov 2003
Posts: 2,155
Likes: 269
I ran the Speed Eng headers to a dual 3" inlet 5x8" case muffler in the tunnel. Took a little tweak to make them fit as the center to center of the headers was just wider than the muffler inlets, Magnaflow advertises the center to center on that muffler at 4". Not a precise answer but maybe it helps.
Thread Starter
Pro
Joined: Aug 2011
Posts: 506
Likes: 57
From: New York
I ran the Speed Eng headers to a dual 3" inlet 5x8" case muffler in the tunnel. Took a little tweak to make them fit as the center to center of the headers was just wider than the muffler inlets, Magnaflow advertises the center to center on that muffler at 4". Not a precise answer but maybe it helps.
