Turn signal wiring problem
Thread Starter
Burning Brakes
Joined: Aug 2018
Posts: 1,098
Likes: 399
From: ARKANSAS
Turn signal wiring problem
I googled this and didn't get anywhere. A while back I replaced my turn signal/DRL with high power bulbs and resistors. I think a wire got shorted but don't know where to look. Left side worked fine as did right side. Then right side failed. So no right front DRL's or front right signal. Can anyone provide a trouble shooting method and/or wiring diagrams? I'm replacing headlights (backordered) and would like to clear this up before new install. Thanks in advance.
I posted this in general discussion and only had one fine member try to help me. Hoping some others might chime in. Thanks
I posted this in general discussion and only had one fine member try to help me. Hoping some others might chime in. Thanks
Race Director
Joined: Sep 2009
Posts: 11,351
Likes: 2,445
From: Eastern
Is it possible that the DRL connector blades are not making good contact? This has been an issue in the past. I googled exactly what you are experiencing and got a good hit. Hopefully, it will give you something to look at.
https://www.corvetteforum.com/forums...t-working.html
https://www.corvetteforum.com/forums...t-working.html
Thread Starter
Burning Brakes
Joined: Aug 2018
Posts: 1,098
Likes: 399
From: ARKANSAS
I found the issue. The harness had pair of wires that seemed to have worn thru and created a short. Repaired wires, but am ordering new harness. Next is installing ANZO headlights.
