New ZR51 Series Spoiler
#41
Race Director
Member Since: Sep 2013
Location: Ft Lauderdale
Posts: 10,470
Received 973 Likes
on
506 Posts
Tech Contributor
here's some pics on how to get the back off:
http://forums.corvetteforum.com/1585659869-post148.html
http://forums.corvetteforum.com/1585659869-post148.html
#42
Le Mans Master
Member Since: Feb 2011
Location: Paoli, IN
Posts: 5,799
Received 398 Likes
on
264 Posts
St. Jude Donor '17, '19
Can you post some side-by-side comparison images? At first glance, it looks like you made it really tall. I feel this would get in the way of putting things in the trunk.
#43
Supporting Vendor
Thread Starter
I will have to snap some pics. We only made it one inch taller, the center isn't raised at all. So visibility and the ease of getting things in and out isn't effected.
#45
Le Mans Master
Member Since: Feb 2011
Location: Paoli, IN
Posts: 5,799
Received 398 Likes
on
264 Posts
St. Jude Donor '17, '19
To be clear, if is possible, can the side-bye-sides be with the spoilers installed? I guess if we can find some pictures of Z51's at the same angles as yours we can just photoshop them together to see the differences.
#46
We took the C7 to a new level with our newly design ZR51 spoiler. The way it should have come from the factory. Installs using the existing holes on a Z51 car or templates are provided for non Z51 cars. It will be available in a paintable version as well as carbon fiber.
This is currently our test fit model and should be ready for purchase in 3-4 weeks.
http://showstopperaccessories.com/pr...-order%22.html
This is currently our test fit model and should be ready for purchase in 3-4 weeks.
http://showstopperaccessories.com/pr...-order%22.html
#47
Safety Car
Is there a reason for this gap on the C7 rear deck lid spoilers?
Even on the factory spoilers the angled part of the spoilers don't fit flush to the body as they do on the ends and middle of the spoiler... Where the deck lid drops down and curves the top angled part of the spoiler does not fit flush against the deck lid area... I noticed this ever since the first C7's were shown to the public.
Even on the factory spoilers the angled part of the spoilers don't fit flush to the body as they do on the ends and middle of the spoiler... Where the deck lid drops down and curves the top angled part of the spoiler does not fit flush against the deck lid area... I noticed this ever since the first C7's were shown to the public.
#49
Supporting Vendor
Thread Starter
#53
Supporting Vendor
Thread Starter
#57
16 Vettes and counting…..
I didn't think it was possible to make an uglier, more tacky looking spoiler than the Z51 version, but you've done it. Sorry....just my opinion.