When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2 days ago I purchased a C7 with the same two-tone red interior! I had never seen that option before, and, to me it was just the right amount of red! Reminded me of the really early two-tone Stingray interiors.
One of the highlights is the red stitching. Looks great on the dash and on the doors too.
Your stitching job looks great, really adds some color to your interior. How did you keep from dying the seats while using your pen?
Went very slowly and made sure the pen tip was wet by shaking it every so often. And I wiped with an old sock every few inches. Like i said, it took me 4 hours. I went into the job planning on 2... Obviously no turning back once I started.
Not accurate. Red stitching is also an available option on the 2LT. I know, I got it.
I've never been able to configure a jet black 2LT with red stitching. If you have two tone or adrenaline red, it just comes that way. But check the order guide: the red and yellow stitching options are only available with 3LT/3LZ. I've verified this with GM reps in person at the Bash.
+1 on the DIY. I have a gray 2LT interior w/ Torch Red exterior. Picked up the "Stained by Sharpie" pen at Hobby Lobby per suggestions here and colored all my stitching. It looks great, and does not damage the seat at all. Very scary using a magic marker on a 2-week old >$80k car though!
What color is the stiching on the Ebony 1LT?
