Johnp94

The Stage 1 wickerbills wrap snug onto Z51 spoiler. Able to use the three inner screws of each side. 1 outer and 1 side screw won’t thread and not needed. Stage one on Z51 spoiler looks great.

LT4CMG

Thank you very much John. This is exact the info I needed. Sincerely appreciate your help.

Kent1999

Good pics. However, the fit at the ends is definitely *not* snug ... I tried the Stage1 winglets on my Z51 spoiler and didn’t like the end gap shown in John’s 4th pic. The problem is that the Z51 spoiler left and right edges tilt inwards while the winglet sides are straight up and down, leaving a V-shaped 1/2” top gap.

On black spoilers the gap isn’t as noticeable unless you really look, but on my torch red, it was very unsightly.

LT1 Z51

I’d go with a Z06 wing.

08velocity

Stage 3 Z06 winglets on Z51 spoiler drilled it, super 3m double side tape and done

hanly2

Is that a z51 spoiler with stage 2 winglets from a Z06? It fits perfect doesn't overhang on the sides

KillerC7zo6

I sold this car. But yea it was my factory Z51 spoiler and I bought the OEM stage 2 wickers and installed them with minor modifying. It fit perfect like if it came from factory

hanly2

Got a pic from the other side? On the blue car up in the thread you can see that the z51 spoiler is not the same shape as the winglet how did you get that outside screw to go in?