FS: BC Racing Coilovers for C7
#1
Burning Brakes
Thread Starter
BC Racing Coilovers for C7 Only $600 Shipped!
SOLD! I had these on my base c7 for around a year. I could never get them quite right for drag racing. Justin Keith (Stangklr) just went 1.29 60' with the same setup, but I could not get them dialed in correctly. These are $995 new. Asking $750 $650 $600 shipped. Includes all 4 single adjustable coil overs, wrenches, and 2 nuts for rear bolts (everything needed for install).
Last edited by Dave01GT; 08-02-2018 at 01:21 PM.
#2
Team Owner
Member Since: Jan 2007
Location: cookeville tennessee
Posts: 28,846
Received 1,762 Likes
on
1,529 Posts
ttt
Great price for a good seller in here free bump for you Dave... Robert
The following users liked this post:
Dave01GT (06-30-2018)
#8
Team Owner
Member Since: Jan 2007
Location: cookeville tennessee
Posts: 28,846
Received 1,762 Likes
on
1,529 Posts
ttt
Dave here is a great guy from his pic's all is in it that you will need. Use your old stock bolts to mount these back into your car. Plus those two tools like piece's is for you to lower r raise the car with. Plus I will say here if you ever want to chg the ride of your car with these r any coilover on your car. The springs are per say really cheap...THAT IS ALL YOU NEED. Robert
Last edited by robert miller; 07-17-2018 at 06:01 PM.
#11
Intermediate
#12
Team Owner
Member Since: Jan 2007
Location: cookeville tennessee
Posts: 28,846
Received 1,762 Likes
on
1,529 Posts
ttt
If your car is not the z51 car just take some jack's or blocks under the springs, then just unbolt the springs, & pull the stock shocks, Put the coilovers on all 4 corners & set your ride height THEN get the car on a Alignment.
Not bad job at all I did it a few time in the c5 The car will ride & handle a ton better if you get the correct spring on the coilovers & ride height set correct... Robert
Not bad job at all I did it a few time in the c5 The car will ride & handle a ton better if you get the correct spring on the coilovers & ride height set correct... Robert
Last edited by robert miller; 07-18-2018 at 05:12 PM.
The following users liked this post:
AF_Z51 (07-18-2018)
#13
Intermediate
#14
Burning Brakes
Thread Starter
It takes a few hours for uninstall of factory suspension and install of these. You undo the upper control arms, sway bars links, shocks, brakes to allow the lower control arm to lower down. Then tighten the ride height bolts all the way up, remove the 4 bolts/2 brackets that hold the leaf spring up and slide the leaf springs out.
The following users liked this post:
AF_Z51 (07-18-2018)
#15
Team Owner
Member Since: Jan 2007
Location: cookeville tennessee
Posts: 28,846
Received 1,762 Likes
on
1,529 Posts
It takes a few hours for uninstall of factory suspension and install of these. You undo the upper control arms, sway bars links, shocks, brakes to allow the lower control arm to lower down. Then tighten the ride height bolts all the way up, remove the 4 bolts/2 brackets that hold the leaf spring up and slide the leaf springs out.