When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
This is a takeoff unit from a 2015 Z06 with less than 800 Miles. Yes, 800, NOT 8000. It comes with all the expensive parts that guys don't think about when buying one of these units.Besides the blower, it has the heat exchanger, coolant hoses, coolant pump, coolant reservoir, LT4 valley cover, the heat and sound pad that goes between the supercharger and the valley cover, tensioner and bracket assembly,complete air cleaner and duct assembly, idler pulleys, harmonic balancer and belt.
There are some small plastic PCV hoses missing and that's about it. It's pretty complete. You can get the adapter plates for $199 online.
$2200 takes it all.
PLEASE TAKE A MOMENT TO VISIT OUR WEBSITE AT WWW.AACORVETTE.COM NOW PARTNERING WITH AFFIRM TO OFFER INTEREST FREE FINANCING!
This is a takeoff unit from a 2015 Z06 with less than 800 Miles. Yes, 800, NOT 8000. It comes with all the expensive parts that guys don't think about when buying one of these units.Besides the blower, it has the heat exchanger, coolant hoses, coolant pump, coolant reservoir, LT4 valley cover, the heat and sound pad that goes between the supercharger and the valley cover, tensioner and bracket assembly,complete air cleaner and duct assembly, idler pulleys, harmonic balancer and belt.
There are some small plastic PCV hoses missing and that's about it. It's pretty complete. You can get the adapter plates for $199 online.
$2200 takes it all.
PLEASE TAKE A MOMENT TO VISIT OUR WEBSITE AT WWW.AACORVETTE.COM NOW PARTNERING WITH AFFIRM TO OFFER INTEREST FREE FINANCING!
It needs a wire harness conversion with the MAP sensor. $399 The adapter plates are $199 And a couple of plastic vent hoses. I think that's about it. All the major stuff is there.
What other additional parts will I need in addition to what you listed to do a complete install on an LT1 ?
.
If you're dry sump you can use this crank pulley no problem. Wet sump you will need a specific hub and space which typically accepts fluid damper pulleys.
You will also need the longer pcv snout for the valley cover(oem is too short with adapter plates), Wiring harness for the water pump and new high pressure fuel line(one time use)
It would be worth while to upgrade to the lt4 injectors and HPFP while you're there too.
I cover a lot of the installation on my channel which is linked in my signature.
06-18-2019, 06:19 PM
LT4 COMPLETE SUPERCHARGER CHANGEOVER for LT1
