Vender Part Build Request
#1
Instructor
Thread Starter
Member Since: Jun 2009
Location: Moab UT
Posts: 245
Likes: 0
Received 0 Likes
on
0 Posts
Vender Part Build Request
GM has really dropped the ball with both the underside of the hood and along the sides of the engine well. So what if we dress up our under hood when some areas really look unfinished. Worst I can remember of any of my Vettes.
So, how about someone coming out with a couple of trim pieces for the sides of the engine bay? Need to leave access to two screws and a hole, but other than that, just a preformed piece to finish it off and to match the other "plastic".
Thanks, Bill
So, how about someone coming out with a couple of trim pieces for the sides of the engine bay? Need to leave access to two screws and a hole, but other than that, just a preformed piece to finish it off and to match the other "plastic".
Thanks, Bill
Last edited by MoabC7; 11-18-2013 at 08:49 PM. Reason: Clarification
#4
Former Vendor
#6
Former Vendor