Halltech Video Installation- 2015 C7 Z06
05-31-2015, 05:57 PM
#1
Supporting Vendor
Thread Starter
Member Since: Mar 2002
Location: Bristol, Tennessee
Posts: 12,988
Received 583 Likes
on
313 Posts
St. Jude Donor '09
Halltech Video Installation- 2015 C7 Z06
Halltech's 2015 Stinger-RZ Installation video.
__________________
"World Class Performance for your Corvette"
Intake Design and Engineering since 1999
Halltech Systems, LLC
262-510-7600
For service email:
orders@halltechsystems.com
www.halltechsystems.com
"World Class Performance for your Corvette"
Intake Design and Engineering since 1999
Halltech Systems, LLC
262-510-7600
For service email:
orders@halltechsystems.com
www.halltechsystems.com
05-31-2015, 08:18 PM
#2
Leeds.io
Member Since: Sep 2003
Location: Cross River, New York
Posts: 4,594
Received 398 Likes
on
239 Posts
St. Jude Donor '14-'15-'16
NCM Sinkhole Donor
Perfect timing! I may do mine tomorrow. 
By chance do you have a full list of the exact tools I'll need for the job? I don't want to get started then realize I have to drive to Home Depot.
Thank you!
Best,
Gene
By chance do you have a full list of the exact tools I'll need for the job? I don't want to get started then realize I have to drive to Home Depot.
Thank you!
Best,
Gene
05-31-2015, 08:56 PM
#3
Maybe scissors too so you can cut the zip ties to size.
Its very easy once you do it the first time.
Good luck, you'll love it!
Last edited by thegeneral101; 05-31-2015 at 08:59 PM.
05-31-2015, 09:37 PM
#4
Supporting Vendor
Thread Starter
Member Since: Mar 2002
Location: Bristol, Tennessee
Posts: 12,988
Received 583 Likes
on
313 Posts
St. Jude Donor '09
8mm
nut driver, which we provideRubber lube, which we provide
Exacto knife
10mm socket and wrench
7mm nut driver
05-31-2015, 09:40 PM
#5
I did it this morning, BEFORE this new video came out. It was not too bad. First video did mention running seal around the top of airbox and NOT the bottom, but new video shows it running around front/side/down to meet the GM rubber seal. I wish I would have known that as I just did the top edge like the first video said.
Jason
Jason
