bapd77

I am by no means a master customizer. I typically mess things up before I have an expert do it, but I decided to customize the shift **** caps I had. I have 2.

Which one looks better:

#1







Or #2

madrob2020

Just an observation, but why can't folks take pics & post them so they are in correct orientation (happens alot on here)? Now back to the show, I prefer the thinner black lined **** & very good job on both!

hcvone

You don't have a gyro chair? Makes all these pics work
they all look good, but the thinner black lined I think looks the best

bapd77

Well, honestly, from my pov, they are all in the correct orientation. Mine must display differently than yours because all six pictures are displayed in the orientation you would see it with 1,3,5,7 at top and 2,4,6,R at the bottom. Do you see something different?

VictorBarron

I vote for the thinner lines.

Always Red Dave

First pictures with the thinner lines looks way better.

JackTripper

Stock

bapd77

Pretty sure stock is not #1 or #2....

madrob2020

Yeah, on my computer some face left, some right, one upside down-but Hey-on the bright side they are all crystal clear!

Warp Factor

As long as you can do whatever you want, you should print the shift pattern backwards, to confuse car thieves.

bapd77

Thank you. I looked on my computer and the same problem. I uploaded them via my ipad and just looked again on my ipad and they are all upright and look normal....who knows...

BOBSZ857

#1. The thinner line gives it a cleaner look.Nice job on both though.

WzUpDoc

Nice job! I personally like number one(the one with the thinner lines). Does this piece just snap on and off like a piece of trim?

bapd77

You have to get a thin pry tool underneath it and push fairly hard to pop it off. It takes quite a bit of power to pop it off, almost feels like its going to break. But it comes off fairly easily once you figure out how it is done. I'd suggest one getting the bottom end up slightly, do the top and it should come straight off.