Magnaflow Cat Back Exhaust System #19236
#321
#323
Drifting
Thread Starter
Your vibration is probably coming from you license plate frame. I put some double sided tape between the frame and license plate and the license plate to the car.
Problem solved.
Problem solved.
#324
CF Senior Member
Ugh...gremlins.
#325
CF Senior Member
Boy, the difference in sound just isn't picked up by the GoPro.
I would say it is nearly twice as loud as stock, but on the vids I took, you just can't tell.
I'll have to get some in-car footage with some rev-match downshifts...
With the Borla X and the MF exhaust, even sitting idle, you "feel" the rumble. Sounds SO much deeper in person.
These are both overnight cold starts, so I didn't get all rev-happy, just started and let it idle.
Before - stock X-pipe and stock exhaust:
After - Borla X-pipe and Magnaflow 19236 exhaust:
I would say it is nearly twice as loud as stock, but on the vids I took, you just can't tell.
I'll have to get some in-car footage with some rev-match downshifts...
With the Borla X and the MF exhaust, even sitting idle, you "feel" the rumble. Sounds SO much deeper in person.
These are both overnight cold starts, so I didn't get all rev-happy, just started and let it idle.
Before - stock X-pipe and stock exhaust:
After - Borla X-pipe and Magnaflow 19236 exhaust:
#326
Sounds awesome but my COOCD is peaked with the unevenness of the tips, I know you said you like it that way just looks like a half-*** installation
#327
I feel like it’s coming from the plastic trim around the back window somewhere. I’ll try better to track it down
#329
Just posted a step by step "how to" on removing the fascia and stock exhaust.
https://www.corvetteforum.com/forums...al-w-pics.html
I haven't noticed this on any other installs, but mine form a nice little arch. I don't know if they're "supposed" to... but I like it.
Straight down from the top. Got mine nearly perfectly flush.
https://www.corvetteforum.com/forums...al-w-pics.html
I haven't noticed this on any other installs, but mine form a nice little arch. I don't know if they're "supposed" to... but I like it.
Straight down from the top. Got mine nearly perfectly flush.
Try switching the center connecting bracket around perhaps? I spent a good amount of time on mine and got them lined up perfectly.
#330
CF Senior Member
I figured if the two brackets are bolted together clean and tight...that should level them out? Guess not.
Can you take a peek at yours and see which bracket is on top? THANKS!
#331
Racer
Yeah, I'll probably give that a shot. I wondered if those plates/brackets may have been welded off a couple degrees.
I figured if the two brackets are bolted together clean and tight...that should level them out? Guess not.
Can you take a peek at yours and see which bracket is on top? THANKS!
I figured if the two brackets are bolted together clean and tight...that should level them out? Guess not.
Can you take a peek at yours and see which bracket is on top? THANKS!
#333
CF Senior Member
Thanks, I had seen the talk about them sticking out 1-2" and made sure that the joints were completely seated before tightening the clamps.
I like this... I'm gonna give the washers a shot.
#336
Advanced
Got it on. Just ran out of time to do any vid in daylight.
It's not that much louder at WOT with my Borla X-pipe though. But idle and cruising volume is perfect now. Xpipe was ok. Now it's as i've always wanted with something noticeable and throaty even just cruising. Sounds so good. The raspiness is gone now.
Thanks, VictorBarron for the tip!
It's not that much louder at WOT with my Borla X-pipe though. But idle and cruising volume is perfect now. Xpipe was ok. Now it's as i've always wanted with something noticeable and throaty even just cruising. Sounds so good. The raspiness is gone now.
Thanks, VictorBarron for the tip!
#340
Le Mans Master
Member Since: Jul 2007
Location: Arkansas
Posts: 5,010
Received 1,344 Likes
on
778 Posts
St. Jude Donor '09-'10-'11-'12-'13-'14-'15-'16-'17,'22-'23
Here's another option, not as inexpensive but looks great.
https://weaponxmotorsports.com/colle...nt=37646356177
https://weaponxmotorsports.com/colle...nt=37646356177
Last edited by BearZ06; 05-12-2019 at 01:43 AM.